IMPORTANCE OF BUS BAR IN A POWER SYSTEM AND ITS APPLICATIONS


#1
                   ELECTRICAL BUS BAR

An electrical bus bar is a conductor or a group of a conductor which is used for collecting electric power from the incoming feeders and distributes it to the outgoing ones it is a junction in which all incoming and outgoing current meets

It collects electrical energy in one location it consists of an isolator and a circuit breaker if any fault occurs the circuit breaker will be tripped off and thus the faulty section of the bus bar is easily disconnected from the circuit

Usually, the rectangular bus bar is used in the power system the metals which are used for making bus bar is copper and aluminum

Mainly it is a bar or strip of copper or brass which conducts electricity within a switchboard or a battery bank it is used for high impedance based application

USAGE OF BUS BAR IN A POWER SYSTEM

Electric power is mainly distributed through wires which are electrically conductive metals wire is really good for distribution because we can do the insulation process on it and over the corners, we can bend it. But in certain cases like in power plants there would be high power for which cables aren’t convenient in that case we could use slabs of metals instead of cables because in case of handling this much power we need to use cables as thick as firehose and which is not applicable in that case we use slabs of metals which is called bus bars

CLASSIFICATION OF BUS BAR

Classification is depending on specified variables at the buses

GENERATION BUS

This is also called as P-V bus in this the voltage magnitude corresponds to its rating which is specified and the voltage magnitude which is maintained constant by injection of reactive power

LOAD BUS

It is called as p-q bus and at this power, the active and reactive power is injected into the network. Phase angle and magnitude of the voltage can be computed the active power p and the reactive power q are specified by this it can be permitted within a tolerable value

SLACK BUS

It absorbs or emits the active or reactive power from the power system it does not carry any load in this the magnitude and phase angle of the voltage is specified

TYPES OF BUS BAR

Single bus bar arrangement

This type of bus bar has only one bus bar along with the switch all the substation equipment like the transformer, generator, and the feeder is connected to this bus bar only

image

MAIN AND TRANSFER BUS ARRANGEMENT

This type of arrangement uses two types of bus bar main bus bar and the auxiliary bus bar bus coupler is used to connect the isolating switches and circuits to the bus bar. Bus coupler is also used to transfer load from one bus to another in case of overloading

DOUBLE BUS DOUBLE BREAKER ARRANGEMENT

In this type of bus bar we would need two bus bar and two circuit breaker it won’t use any additional devices like bus coupler or switch this type of design provides maximum flexibility
image